Washdown Duty Motors Features and Benefits • White epoxy paint gives superior corrosion resistance and is USDA approved. • The stainless steel shaft has a contact lip seal and V-ring slinger to protect bearings from high-pressure spray. • Rust resistant treatment on the rotor • All three phase ratings are Energy $aver designs and meet NEMA 12-6B • Motor has drain plugs 90° apart on both ends of motor to permit drainage of condensation from any mounting position. • Steel inserts in endshields to eliminate hammered-out bearing housings. • The stainless steel nameplate provides permanent motor identification. • Large sized (12 cubic inch) conduit box fully gaskets with lip seal to keep out moisture. • Cover includes captive screws • Corrosion-resistant hardware to retard rust and improve motor serviceability. • Housing fits are sealed to prevent entrance of moisture and guard against corrosion. • Class F insulation with Class B rise for longer motor life. • Motors are suitable for operation in ambient temperatures up to 65°C at 1.0 service factor. • Suitable for use on pulse-width modulated and adjustable speed drives to speed range of 10:1 constant torque. • UL and CSA component recognition to meet local codes. a reversing device Back to Commercial Products Page For more information, contact: GE Commercial Motors By Regal-Beloit 1946 West Cook Road Fort Wayne, Indiana 46818 Phone (260) 416-5400 Fax (260) 416-5460 GE is a trademark of General Electric Company and is used under license to REGAL-BELOIT CORPORATION.